Re: Sony Vaio, LinkSys EC2T & 5.0-CURRENT ...

[email protected] wrote:

> Hello all,
> I had also similar problems with my Sharp PC-PJ1 with the same 
> PCI-bridge chipset as both of you and a Melco LPC2-T ethernet card. In 
> my case the card and the bridge were assigned to the same irq, which of 
> course preventeed me from doing a web-install.
> I've solved it by editing the list of free irqs in 
> /etc/defaults/pccard.conf (editing /etc/pccard.conf had no effect), 
> adding in /boot/loader.conf hw.pcic.intr_path=1 as well as hw.pcic.irq=0 
> (from instructions on <http://www.clave.gr.jp/ml/bsd-
> nomads/200111/msg00029.html>), checking etc/rc.conf and finally doing a 
> cold start.

Cyril!

   Thanks for the pointer...   I went to that web page to take
a look... but - it seems to be non-english (or, maybe I have
some bad fonts installed.)   Could you send me more details on
exactly how to make this work...  it may just be the answer I've
been looking for!

	- Thanks! -
	- Dave Rivers -


> Indicating irq's in the kernel conf as well as during configure at 
> startup had no effects.
> This is with 4.5, not CURRENT, I hope it works for you.
> hth
> Cyril
> On Dimanche, juin 2, 2002, at 07:52 , Thomas David Rivers wrote:
> 
> >
> > "Marc G. Fournier" <[email protected]> wrote:
> >
> >> 	According to dmesg, I have:
> >>
> >> pcic0: <Ricoh RL5C475 PCI-Cardbus Bridge> irq 9 at device 10.0 on pci0
> >> pcic0: PCI Memory allocated: 0x44000000
> >> pccard0: <PC Card bus (classic)> on pcic0
> >>
> >> 	If I pull out the card, the machine itself hangs ... and searching
> >> on Google, it talks about pccard + shared interrupts ... and on this, 
> >> the
> >> internal ethernet (fxp0) is using irq 9 and the USB controller (uhci0) 
> >> is
> >> using irq 9 ...
> >>
> >
> >    I'm having similar problems with a Sony VAIO F480 and 4.5-RELEASE.
> > (see my postings on the -stable list.) (Same Ricoh RL5C475 chip.)
> 
> 

To Unsubscribe: send mail to [email protected]
with "unsubscribe freebsd-mobile" in the body of the message