Re: Cardbus issues in -current (broken again)
"M. Warner Losh" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
In message: <[email protected]> Peter Losher <[email protected]> writes: : Around six weeks ago, there were some fixes Warner put in to -CURRENT so : that Cardbus cards would be recognized at boot time on laptops such as : my own (Inspiron 5100) instead of having to re-insert the card (as it : would throw up "cbb0: Cardbus activation failed" otherwise) after the : system finishes booting. : : That was working all fine and well, until just over two weeks ago, when I : updated to the latest -CURRENT cut... Ever since then, Cardbus refuses : to work at all. (My old PC Card wireless NIC still works fine) It just : repeatedly spurts out "cbb0: Cardbus activation failed" when : (re)inserting the Atheros based Cardbus NIC I had been using quite : successfuly before. : : Have there been any changes to the Cardbus support in the last couple of : weeks? One side effect is that FreeBSD now detects the onboard Broadcom : NIC again (It hadn't been detected since the MB on this laptop was : replaced by Dell tech support earlier this year) Because of this, I did : try to disable the onboard NIC to see if that fixed the Cardbus : detection, but to no avail. :) Peter, can you send me a boot -v with hw.cbb.debug=1, hw.cardbus.debug=1 and hw.cardbus.cis_debug=1 (these last three set at the loader prompt or in /boot/loader.conf). Warner _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"