Re: Xfree86 4.3.0 under 5.2.1-Relase on Compaq Armada e500

On Tuesday 06 July 2004 11:11 am, Frank Altpeter wrote:
> Hello!
>
> Michael McCormack wrote on 2004-07-07 01:51:39 +1000:
> > Having severe problems getting xfree to run on this machine;
> >
> > Compaq Armada e500
> > ATI Rage Mobility P/M
> > 8MB (?) Video RAM -- I think this card steals system RAM.
> > 384 MB system RAM
> >
> > Have tried around six different XF86Config files both generated from
> > xf86cfg and found in various places, including the ones posted on the
> > FLCL. I have tried these with ACPI enabled and disabled, but the result
> > is always the same.
> >
> > startx hangs at:
> > (==) Using config file: "/etc/X11/XF86Config"
> >
> > The logfile reports nothing after the PCI probe stuff.
> >
> > The system doesn't lock up completely; it still responds to
> > ctrl-alt-del, but that's all it will do.
> >
> > I can post logfiles and/or dmesg output if anyone thinks it'll help. I'm
> > still running the GENERIC kernel.
> >
> > Any help appreciated.
>
> First of all, i would strongly suggest to update to 5.2-CURRENT ...
> the 5.2.1 release is not really useable on e500.
> Then update ports and build a new XFree and start then try to build
> a new "xfree86 -configure" config and test again.

Let's also not forget /usr/ports/x11/xorg 
XFree can easily be replaced with that.

-- 
Best regards,
Chris

-- 
This message has been scanned for viruses and dangerous 
content by MailScanner, and is believed to be clean.
ClamAV virus dat updated: Tue Jul 6 2004 at 03:02:57
daily.cvd updated (version: 392, sigs: 1405, f-level: 2, builder: tomek)

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"