Re: D-Link DWL-650 Wireless PC Card RevP

[email protected] wrote:

>Hi,
>
>i have a problem with my D-Link DWL-650 RevP PC Card on my 5.x-current. After putting the in i have the following message on my monitor:
>
>wi0: <D-Link DWL-650 Wireless PC Card RevP> at port 0x400 -0x407f irq 11 function 0 config 1 on pccard0
>wi0: [GIANT-LOCKED]
>wi0: wi_cmd: busy bit won´t clear.
>:init failed
>device_attach: wi0 attach returned 6
>
>According to the hardware_list - the current version supports this card - where could be the problem?
>
>I tried NDIS as well, but after "kldload ndis.ko" and "kldload if_ndis.ko" I have the same message as above and no "ndis0"-interfaces in addition.
>
>Anyone any idea?
>Thanks in advance
>-paul
>  
>

Have you done the following ?

In /boot/loader.conf

hw.cbb.start_memory="0x20000000"
hw.pci.allow_unsupported_io_range=1

I know this generally is the fix to other problems, but my DWL-660 is 
working.

wi0: <D-Link D-Link Air DWL-660 Wireless PC Card> at port 0x2080-0x20bf 
irq 11 function 0 config 1 on pccard0
wi0: [GIANT-LOCKED]
wi0: using Lucent Technologies, WaveLAN/IEEE
wi0: Lucent Firmware: Station (8.10.1)
wi0: Ethernet address: 00:05:5d:24:96:17
wi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps


_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"