IBM T42 em0 EEPROM Checksum not valid
Eric van Gyzen <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Organization | ISDS, Duke University |
| Message-ID | <[email protected]> |
I'm trying to install 5.2.1-RELEASE on my new IBM ThinkPad T42. The em(4)
driver complains:
em0: <Intel(R) PRO/1000 Network Connection, Version - 1.7.19> ...
em0: The EEPROM Checksum Is Not Valid
em0: Unable to initialize the hardware
device_probe_and_attach: em0 attach returned 5
I can configure an IP address on the interface, but (of course) it doesn't
actually send/receive traffic. The link keeps bouncing up and down. I've
seen "em0: watchdog timeout -- resetting" a few times. pciconf(8) says:
em0@pci2:1:0: class=0x020000 card=0x05491014 chip=0x101e8086
rev=0x03 hdr=0x00
Any ideas? Thanks!
Eric
PS: I just realized that Intel's PCI Vendor ID is 8086...now that's funny.
--
Eric van Gyzen Sr. Systems Programmer
http://www.stat.duke.edu/~vangyzen/ ISDS, Duke University
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"