Re: 5.2-CURRENT still not working on my mitac 8080
"David W. Chapman Jr." <[email protected]>
| Newsgroups | gmane.os.freebsd.current,gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
John Baldwin wrote: >On Thursday 15 July 2004 10:08 am, David W. Chapman Jr. wrote: > > >>John Baldwin wrote: >> >> >>>On Wednesday 14 July 2004 02:57 pm, David W. Chapman Jr. wrote: >>> >>> >>>>John Baldwin wrote: >>>> >>>> >>>>>On Wednesday 14 July 2004 09:25 am, David W. Chapman Jr. wrote: >>>>> >>>>> >>>>>>When I boot in safe mode here is the console output >>>>>> >>>>>>pir0: <PCI Interrupt Routing Table: 9 Entries> on motherboard >>>>>>$PIR: BIOS IRQ 10 for 1.4.INTA does not match link 0x61 irq 5 >>>>>>pci0: <PCI bus> on pcib0 >>>>>> >>>>>> >>>>>Look for a BIOS upgrade. It sounds like your BIOS has badly busted >>>>>interrupt routing. >>>>> >>>>> >>>>I think I can get one, I don't have a problem running 4.X though, would >>>>that be consistent with the problem you described? >>>> >>>> >>>4.x isn't smart enough to ask the BIOS how to route interrupts from the >>>BIOS tables, it just assumes that the way it booted is ok. >>> >>> >>Unfortunately I have just upgraded to the latest BIOS revision and the >>problem still exists. I guess I'm dead in the water as far as 5.x goes? >> >> > >Probably. Is it broken when using ACPI as well? > > > with or without ACPI and safe mode yield no luck. I guess its DragonFly or Fedora Core :) _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[email protected]"