RE: Thinkpad 600E and 5.2

I just dug out a TP600E, installed 4.10........

Xircom RE100 - works fine (16 bit card)
Xircom RealPort Cardbus Ethernet 10/100-Modem 56 - no go,  expected as
no cardbus support in 4.x
D-Link DFE650 - works fine
3Com Megahertz 3CCFE574BT - works fine

The "E" is a 2645-5JA

Just FYI these also work in a TP600, TP600X

If I use 5.x I need to run OLDCARD but the above cards work there also

regards
Pete


> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Gary Kline
> Sent: Thursday, July 29, 2004 3:07 AM
> To: Victor Bratsev
> Cc: FreeBSD Mobile Mailing List
> Subject: Re: Thinkpad 600E and 5.2
>
>
> On Wed, Jul 28, 2004 at 10:01:26AM +0400, Victor Bratsev wrote:
> > You should look at HARDWARE.txt for devices that work
> with freebsd or ask
> > about specific device, maybe somebody is using it.
> >
> > I've got TP600E with Xircom RE-100 (with some unresolved
> issues) under 4.7-R
> > and 4.10-R
> >
>
> 	(Can you describe what your "unresolved issues" are?)... .
>
> 	Good points.  It seems to me that  any NIC card that works on
> 	a laptop should work on a Thinkppad.  I'm looking at the
> 	3Com type cards and anything that uses the DEC/Intel 21143
> 	chipset/logic.  The Linksys cards have workrd flawlessly
> 	on four of my tower systems.
>
> 	According to the 4.8R HARDWARE.txt list there is:
>
>      * Linksys EC2T/PCMPC100/PCM100, PCMLM56, EtherFast
> 10/100 PC Card,
>        Combo PCMCIA Ethernet Card (PCMPC100 V2)
>
> 	If anyone on -mobile has one of these on 4.8 or later
> 	I'll try one of these.
>
> 	Anybody??
>
> 	thanks much,
>
> 	gary
>
>
>
>
> > ----- Original Message -----
> > From: "Gary Kline" <[email protected]>
> > To: "FreeBSD Mobile Mailing List" <[email protected]>
> > Sent: Wednesday, July 28, 2004 9:16 AM
> > Subject: Thinkpad 600E and 5.2
> >
> >
> > >
> > > Folks,
> > >
> > > Many months ago I tried a floppy install of 5.3 on my
> > > HP Kayak.  It poisoned.  A few hours ago today I downloaded
> > > the latest 5.2 floppy set nd booted my ThinkPad 600E.
> > > The boot *did* see my Xircom Ethernet II adaptor, but the
> > > kernel poisoned and rebooted after 15 seconds.
> > >
> > > Eventually I will be able to use the Xircom.  But for now
> > > it's time to go back to old, STABLE 4.8.  Soooo, nutshell,
> > > what cards will work with my ISDL CAT5 cable in 4.8?  I'd like
> > > the name and model and any other id regarding the card so
> > > that I get it right next time.
> > >
> > > Thanks in advance, guys,
> > >
> > > gary
> > >
> > > --
> > >    Gary Kline     [email protected]   www.thought.org
>   Public service
> > Unix
> > >
> > > _______________________________________________
> > > [email protected] mailing list
> > > http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> > > To unsubscribe, send any mail to
> "[email protected]"
> > >
> >
> > _______________________________________________
> > [email protected] mailing list
> > http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> > To unsubscribe, send any mail to
> "[email protected]"
>
> --
>    Gary Kline     [email protected]   www.thought.org
> Public service Unix
>
> _______________________________________________
> [email protected] mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> To unsubscribe, send any mail to
> "[email protected]"
>
>

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"