Re: ToPIC95B cardbus on old laptop

Hello Andrew,

On Friday 03 September 2004 12:50, Andrew Belashov wrote:
> Tijl Coosemans wrote:
> | On Thursday 02 September 2004 08:04, Andrew Belashov wrote:
> |>Tijl Coosemans wrote:
> |>| I'm having problems to get my Xircom card working. It doesn't
> |>| seem to be able to allocate mem. I think in 4-stable it used
> |>| 0xd1000. Anyway, I've set the syctl variabe hw.xe.debug to 2
> |>| and included the output below. The first thing I noticed was
> |>| that it seems to think it's a RealPort card while this
> |>| certainly isn't the case.
> |>|
> |>| There are a couple messages related to this in the archives,
> |>| even a patch, but the code has changed since then and it no
> |>| longer applies.
> |>|
> |>| I'm using an OLDCARD kernel by the way. (NEWCARD doesn't seem
> |>| to work with this ToPIC95B).
> |>
> |>Try NEWCARD with patch from PR kern/69127:
> |><http://www.freebsd.org/cgi/query-pr.cgi?pr=69127>
> |>
> |>Boot verbosely ("boot -v" at loader prompt).
> |>
> |>Before inserting card do following:
> |># sysctl hw.cbb.debug=1
> |># sysctl hw.pccard.debug=1
> |># sysctl hw.pccard.cis_debug=1
> |># sysctl hw.cardbus.debug=1
> |># sysctl hw.cardbus.cis_debug=1
> |>
> |>Post dmesg into maillist.
> |
> | As I briefly mentioned, NEWCARD doesn't work for me, so I didn't
> | actually get any info from inserting the card. However, I figured
> | you might still be interested in the dmesg so here it is.
> |
> | I also found a message in the archives with apparently exactly
> | the same problem. It was fixed by enabling acpi, which this
> | laptop unfortunately does not support.
> |
> | http://lists.freebsd.org/pipermail/freebsd-current/2004-April/026
> |001.html
> |
> | Also, when I put this laptop in a docking station, there's a LOR
> | when probing the extra slots (cbb2) and the kernel crashes with a
> | page fault. Let me know if you want a dmesg of that.
>
> For NEWCARD in additional to first patch:
>
> Try following at boot prompt:
>
> set hw.pci.allow_unsupported_io_range="1"

This didn't do anything, and I think it has been removed from the code 
a while ago.

> Or try patch from PR/66848
> <http://www.freebsd.org/cgi/query-pr.cgi?pr=66848>

This patch isn't really up to date, but I figured out where to put all 
the pieces and lo and behold, it worked! Congratulations!
To get my Xircom card working I also needed the the exca.c patch you 
mentioned. Without it, the system completely locked up when I 
inserted the card and crashed when I removed it again.

Many many thanks!

Tijl
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"