Re: pcm broken in 5.3-BETA3 (Insprion 5100)(PSM ?)
Vince Hoffman <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
On Mon, 6 Sep 2004, Peter Losher wrote: > Hi - > > I updated my Dell Insprion 5100 from BETA1 to BETA3, and now the > integrated touchpad is no longer recognized as a pcm device. (ACPI on or > off have no effect) Using a external USB mouse works fine. > > Here are the relevant device.hints I am using: > > -=- > hint.psm.0.at="atkbdc" > hint.psm.0.irq="12" > hint.psm.0.flags="0x200" > -=- your flags say to disable the mouse model probe. you could try removing that. However if i dont have that flag my system Locks hard when i run moused. (synaptic touchpad on a tosh portege A100) > > Any ideas? > > Best Wishes - Peter > -- > [email protected] | ISC | OpenPGP Key E8048D08 | "The bits must flow" > _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"