Re: Help with Ath0

Hi,

I am running ath, but 2.4 GHz (DWL-G520) on FreeBSD 5.3 BETA3 without
problems. 

Did tou tryied to fix speed for example on 18Mbps on both sides?

try ifconfig ath0 mode 11a media OFDM/18Mbps on both sides.

Or try any other configuration - ifconfig -m

With new drivers from Sam I have problems on 11g, system is unstable

Tomas Randa


On Wed, 2004-09-08 at 14:09, Everton - Matrix wrote:
> Hi there folks,
> 
> This issue has been discussed before on this list, but i could not solve my
> problems reading the previous messages...so, here it go! :-)
> 
> I´m trying to use the ath0 drivers on a FreeBSD 5.3Beta2 box, but i´m having
> some problems with it...
> 
> While trying to use the old drivers, things wasn´t going that great, I was
> getting a bunch of duplicate packets, then following Sam instructions (to
> another guy who was having the same problems...) I´ve upgraded the ath0
> drivers to the newest one, but after that, I can´t even "ping" anymore...and
> I´m getting the error message, as follows:
> 
> ath0: bogus xmit rate 0x3
> 
> Can anyone give me a help on this issue?
> 
> Here follows some specifications of my setup, it´s a FreeBSD 5.3BETA2 server
> with a DLink AG 520 PCI wireless card, the mode is 802.11a and the link
> distance is 5,5km long. I´m also using a 22db/5.8G Anthen.
> 
> One interesting fact is that I´ve tested this in a shorter distance link
> (1km), and it all worked great. (with the old drivers!!!)
> 
> Thanks in advance and Best Regards.
> 
> []´s
> 
> Everton
> 
> _______________________________________________
> [email protected] mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
> To unsubscribe, send any mail to "[email protected]"

_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"