Vaio X505 (general questions).

Hi,

I've picked up a Vaio X505CP in Japan and I'm having troubles with the
suspend/standby stuff (also I can't get the backlight off, if anybody
has any suggestions for that ;).  What basically happens is that when I
try zzz the machines shuts down and the screen switches off -- an LED
flashes to indicate it's not ``off''.  When I hit the spacebar the disk
whirs up, the LED turns a solid green (indicating on) but nothing else
hapens.  The screen doesn't come on, and the system doesn't reset on
CTRL+ALT+DEL.  After I powered down and started up again I notice that I
have this in messages:

Sep 10 01:51:10 tokyo acpi: resumed at 20040910 01:51:10

  Any ideas?  Here is some info I think might be useful:

hw.acpi.supported_sleep_state: S3 S4 S5
hw.acpi.power_button_state: S5
hw.acpi.sleep_button_state: S3
hw.acpi.lid_switch_state: NONE
hw.acpi.standby_state: S1
hw.acpi.suspend_state: S3
hw.acpi.sleep_delay: 1
hw.acpi.s4bios: 0

% dmesg
Copyright (c) 1992-2004 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 5.3-BETA3 #0: Wed Sep  8 02:15:57 BST 2004
    [email protected]:/usr/src/sys/i386/compile/TOKYO
WARNING: debug.mpsafenet forced to 0 as ipsec requires Giant
WARNING: MPSAFE network stack disabled, expect reduced performance.
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Pentium(R) M processor 1100MHz (1091.76-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x695  Stepping = 5
  Features=0xa7e9f9bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,TM,PBE>
real memory  = 531496960 (506 MB)
avail memory = 510431232 (486 MB)
npx0: [FAST]
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <SONY> on motherboard
acpi_ec0: <Embedded Controller: GPE 0x1c> port 0x66,0x62 on acpi0
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x1008-0x100b on acpi0
cpu0: <ACPI CPU (4 Cx states)> on acpi0
acpi_tz0: <Thermal Zone> on acpi0
acpi_lid0: <Control Method Lid Switch> on acpi0
acpi_button0: <Power Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pci0: <base peripheral> at device 0.1 (no driver attached)
pci0: <base peripheral> at device 0.3 (no driver attached)
agp0: <Intel 8285xM (85xGM GMCH) SVGA controller> port 0x1800-0x1807 mem 0xe0000000-0xe007ffff,0xe8000000-0xefffffff irq 9 at device 2.0 on pci0
agp0: detected 3964k stolen memory
agp0: aperture size is 128M
pci0: <display> at device 2.1 (no driver attached)
uhci0: <Intel 82801DB (ICH4) USB controller USB-A> port 0x1820-0x183f irq 9 at device 29.0 on pci0
uhci0: [GIANT-LOCKED]
usb0: <Intel 82801DB (ICH4) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1: <Intel 82801DB (ICH4) USB controller USB-B> port 0x1840-0x185f irq 9 at device 29.1 on pci0
uhci1: [GIANT-LOCKED]
usb1: <Intel 82801DB (ICH4) USB controller USB-B> on uhci1
usb1: USB revision 1.0
uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
pci0: <serial bus, USB> at device 29.7 (no driver attached)
pcib1: <ACPI PCI-PCI bridge> at device 30.0 on pci0

ACPI link \\_SB_.PCI0.LPCB.LNKF has invalid initial irq 3, ignoring
^-- maybe this is something?

pci2: <ACPI PCI bus> on pcib1
cbb0: <RF5C475 PCI-CardBus Bridge> irq 9 at device 5.0 on pci2
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
fwohci0: <Ricoh R5C551> mem 0xe0201000-0xe02017ff at device 5.1 on pci2
fwohci0: [GIANT-LOCKED]
fwohci0: OHCI version 1.0 (ROM=1)
fwohci0: No. of Isochronous channels is 4.
fwohci0: EUI64 08:00:46:03:01:b5:31:ea
fwohci0: Phy 1394a available S400, 2 ports.
fwohci0: Link S400, max_rec 2048 bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
sbp0: <SBP-2/SCSI over FireWire> on firewire0
fwe0: <Ethernet over FireWire> on firewire0
if_fwe0: Fake Ethernet address: 0a:00:46:b5:31:ea
fwe0: Ethernet address: 0a:00:46:b5:31:ea
fwohci0: Initiate bus reset
fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me)
firewire0: bus manager 0 (me)
fxp0: <Intel 82801DB (ICH4) Pro/100 VE Ethernet> port 0x2000-0x203f mem 0xe0200000-0xe0200fff irq 9 at device 8.0 on pci2
miibus0: <MII bus> on fxp0
inphy0: <i82562EM 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
fxp0: Ethernet address: 08:00:46:e9:f5:58
fxp0: [GIANT-LOCKED]
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH4 UDMA100 controller> port 0x1810-0x181f,0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 at device 31.1 on pci0
ata0: channel #0 on atapci0
ata1: channel #1 on atapci0
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
pcm0: <Intel ICH4 (82801DB)> port 0x18c0-0x18ff,0x1c00-0x1cff mem 0xe0100800-0xe01008ff,0xe0100c00-0xe0100dff irq 9 at device 31.5 on pci0
pcm0: [GIANT-LOCKED]
pcm0: <Analog Devices AD1981B AC97 Codec>
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: [GIANT-LOCKED]
psm0: model Generic PS/2 mouse, device ID 0
acpi_cmbat0: <Control Method Battery> on acpi0
acpi_acad0: <AC Adapter> on acpi0
orm0: <ISA Option ROMs> at iomem 0xdc000-0xdffff,0xd8000-0xdbfff,0xc0000-0xcffff on isa0
pmtimer0 on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250 or not responding
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounter "TSC" frequency 1091764998 Hz quality 800
Timecounters tick every 10.000 msec
IPsec: Initialized Security Association Processing.
acpi_cpu: throttling enabled, 8 steps (100% to 12.5%), currently 100.0%
ndis0: <Sony 802.11a/b/g Wireless LAN Adapter> mem 0xe0210000-0xe021ffff irq 9 at device 0.0 on cardbus0
ndis0: [GIANT-LOCKED]
ndis0: NDIS API version: 5.1
NDIS: could not find file regAdd.txt in linker list
NDIS: and no filesystems mounted yet, aborting NdisOpenFile()
ndis0: Ethernet address: 08:00:46:c7:89:0b
ndis0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
ndis0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
ndis0: 11g rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
ad0: 19073MB <TOSHIBA MK2004GAL/JC101A> [38753/16/63] at ata0-master UDMA100
Mounting root from ufs:/dev/ad0s1a
WARNING: / was not properly dismounted
NDIS: open file /compat/ndis/regAdd.txt failed: 2
WARNING: /usr was not properly dismounted
/usr: mount pending error: blocks 16 files 7
WARNING: /var was not properly dismounted
/var: mount pending error: blocks 80 files 20
ndis0: link up
ndis0: link up

-lewiz.

-- 
I was so much older then, I'm younger than that now.  --Bob Dylan, 1964.
------------------------------------------------------------------------
-| msn:[email protected] | jabber:[email protected] | url:www.lewiz.org |-

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (FreeBSD)

iD8DBQFBQQLHItq0KFQv7T8RAkJ4AJ0Q2raF4xt52Np3xd7qeCdFB5aTyQCg6ef8
AsDTFZ1O/edOQwBQzFgsRF0=
=MqU9
-----END PGP SIGNATURE-----