ath driver
"Markie" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <000901c4a2f9$f3145950$f800000a@laptop> |
I'm dual booting with FreeBSD on my laptop now, 5.3-BETA5. I have a D-link wireless card, DWL-G650, which is based on the Atheros chip. When I do a kldload if_ath.ko it prints a load of stuff saying speeds etc and ifconfig then has a ath0 device :-) However, I tried configuring it and it all seems a bit random. It'll still say "no carrier" still and sometimes it will go into the associated state and I can ping machines, but then it'll go back to no carrier again? The length is stays in the associated state seems a bit random. Sometimes i'll get it for maybe a minute, sometimes it'll just immediately switch back to no carrier. Is anyone using the ath driver with success? I'm all of 10cm away from the access point too.... Suggestions? _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"