Re: NDISsulator: Setting up a 3Com pc card
Jochen Gensch <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile,gmane.os.freebsd.current |
|---|---|
| Message-ID | <[email protected]> |
Tim Bishop wrote:
> Any suggestions?
No :-(
But here is my panic message if that helps someone. I had to type it
down, so hopefully there is no mistake in there...
I got this message, when I tried to bring ndis0 up at boot time by
rc.conf with wep enable. I haven't tried an open system, yet.
Fatal trag 12: page fault while in kernel mode
cpuid = 0; apic id =00
fault virtual address = 0x0
fault code = supervisor write, page not present
instruction pointer = 0x8:0xe1dbf8f0
frame pointer = 0x10:0xe1dbf988
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gra 1
processort flags = interrupt enabled, resume, IOPL = 0
current process = 195 (ifconfig)
trap number = 12
panic: page fault
cpuid = 0
Cheers, Jochen
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"