Re: install hangs on IBM Thinkpad X23
Jon Drews <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
Hi Dru:
I came across this advice:
This is just a shot in the dark by try doing:
sysctl hw.allow_unsupported_io_range=1
Then try loading the snd module.
http://lists.freebsd.org/pipermail/freebsd-current/2003-December/016544.html
Also this suggestion may help:
http://docs.freebsd.org/cgi/getmsg.cgi?fetch=43475+0+archive/2002/freebsd-multimedia/20020414.freebsd-multimedia
FWIW, this also works for me on an X23 (2662-E5U to be exact). For the logs,
the needed kernel config lines are:
device smbus
device ichsmb
device smb
device pcm
options PCI_ENABLE_IO_MODES
(I seem to get boot hangs if I leave pcm out).
---------------------------------------------------------------
The FLCL has a link to these other suggestions:
http://web.cs.cmu.edu/~dpelleg/X23_freebsd.html
You may want to look there also.
Kind regards,
Jonathan
On Sun, 3 Oct 2004 12:23:15 -0400 (EDT), Dru <[email protected]> wrote:
>
> Hello,
>
> I keep running across the same error when installing via floppy for 4.9,
> 4.10, and 5.2.1. When the initial kernel loads from mfsroot.flp, it always
> hangs solid (requiring a cold boot) at this line:
>
> pci0: <multimedia, audio> at device 31.5 (no driver attached)
>
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"