Re: resetting a cardbus device
"M. Warner Losh" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
In message: <[email protected]> Mike Tancsa <[email protected]> writes: : I am working with a cardbus modem that is somewhat buggy. Unfortunately, I : dont have much documentation for its AT Command set (its a GPRS modem) and : at&f or atz does not seem to reset it properly when it goes "wonky". The : only way is to pull it out and put it back in. Unfortunately, I want to : remotely deploy this device so I cant physically do that. A reboot seems : to work, but thats not the greatest thing to do either. : : dmesg shows : : : cbb0: <RF5C476 PCI-CardBus Bridge> mem 0xe6400000-0xe6400fff irq 12 at : device 10.0 on pci0 : cardbus0: <CardBus bus> on cbb0 : pccard0: <16-bit PCCard bus> on cbb0 : cbb1: <RF5C476 PCI-CardBus Bridge> mem 0xe6405000-0xe6405fff irq 5 at : device 10.1 on pci0 : cardbus1: <CardBus bus> on cbb1 : pccard1: <16-bit PCCard bus> on cbb1 : : sio4: <Sony Ericsson GC82 PC Card> at port 0x3e8-0x3ef irq 12 function 0 : config 32 on pccard0 : sio4: type 16550A : sio4: unable to activate interrupt in fast mode - using normal mode : : This is a RELENG_5 box from 5.3-STABLE FreeBSD 5.3-STABLE #0: Wed Dec 22 You could create a sio_pci.ko module that just has the sio_pci.c file in it. You can also create a custom sio.ko module w/o this. Then you can unload/load that module. Warner _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"