Re: Trouble with APM suspend in 5.3-R

Dave Walton wrote:
> Andrew Belashov wrote:
> 
>> Dave Walton wrote:
>>
>>> I've been unable to get APM suspend/resume to work with 5.3-R on my 
>>> Thinkpad 770Z.  As released, 'apm -z' causes a lockup (it worked fine 
>>> in 4.x).  Revision 1.233 of ata-all.c fixes that, and 'apm -z' now 
>>> causes the system to properly suspend to disk, as it had before.  
>>> However, when the system resumes, it spits out three errors regarding 
>>> pir0, then panics.  This happens with or without your patch applied 
>>> to ata-all.c.
>>>
>>
>> Try attached patch as workaround.
> 
> 
> A good effort!  That is precisely the error I saw.  Hopefully, that 
> removed call to pci_pir_biosroute() doesn't do anything important.
> 
> Unfortunately, this had no effect at all on the panic.  Please see my 
> next reply to Gleb Smirnoff for details on the panic.  Perhaps it will 
> mean something to you.

Ok. Don't use my patch anymore.
Try to update BIOS.

> 
>> ------------------------------------------------------------------------
>>
>> --- sys/i386/pci/pci_pir.c.orig    Fri Jul 30 19:51:30 2004
>> +++ sys/i386/pci/pci_pir.c    Sun Nov 14 21:47:33 2004
>> @@ -717,8 +717,12 @@ pir_resume(device_t dev)
>>                  "Using %d.%d.INT%c to route link %#x to IRQ %d\n",
>>                      pd.bus, pd.device, pd.pin + 'A',
>>                      pci_link->pl_id, pci_link->pl_irq);
>> +#if 0
>>              error = pci_pir_biosroute(pd.bus, pd.device, 0, pd.pin,
>>                  pci_link->pl_irq);
>> +#else
>> +            error = 0;
>> +#endif
>>              if (error)
>>                  device_printf(dev,
>>                  "ROUTE_INTERRUPT on resume for link %#x failed.\n",
> 

With Best Regards,
Andrew Belashov.
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"