Re: Using VESA to restore display settings on resume

В ср, 02/03/2005 в 11:18 -0800, Kevin Oberman пишет:
>> From: Vladimir Grebenschikov <[email protected]>
>> Date: Tue, 01 Mar 2005 23:31:15 +0300
>> Sender: [email protected]
>> 
>> В пн, 28/02/2005 в 20:26 +0000, Ian Dowse пишет:
>> >In message <[email protected]>, Ian Dowse writes:
>> >>In message <1109545918.1537.8.camel@localhost>, Vladimir Grebenschikov writes:
>> >>>Also if I try this patch with vesa module loaded it just carsh in vm86
>> >>>mode on zzz (curproc acpiconf).
>> >>
>> >>It is probably necessary to get this working with VESA to have much
>> >>of a chance of it helping, since otherwise only the basic VGA
>> >>registers will be saved and restored.
>> >>
>> >>One possible reason for the vm86 crash is that it appears our VESA
>> >>code cannot handle saving more than 4k of state data. Does it make
>> >>any difference if you revert the part of the patch that changed
>> >>STATE_MOST to STATE_ALL? i.e. change the two uses of STATE_ALL in
>> >>vesa.c back to STATE_MOST. I found that with SAVE_MOST, I needed
>> >>to switch to X and back before the console would display, but the
>> >>backlight did come on immediately.
>> >
>> >I've updated the patch at
>> >
>> >	http://people.freebsd.org/~iedowse/vesa_restore.diff
>> >
>> >so that the VESA code allows up to 8k of state storage and will
>> >fail if the BIOS claims to need more space. Could you try this with
>> >the vesa module loaded and with both 0 and 1 for hw.acpi.reset_video?
>> 
>> I've rechecked patch with fresh kernel build and firewire console.
>> 
>> It does not panics and does not awake :( 
>> As in previous variant it sleeps ok, but on awake it only spin up HDD.
>> No any other activity seen, it does not react on keys, firewire console
>> is dead.
>> It does not answer on network activity.
>> 
>> Probably It hangs while try to restore console, and I should try to
>> disable console at all ? 
>
>Is the disk active LED on? Many systems have had trouble with this,
>although I thought Soren had fixed this.

Both led and sound, it spin-up, shows some activity by both led and
sound, and then stop any activity.

Probably I should try kernel without ata ? (only md for root) 

>If the LED is on, you might want to try ATA MkIII.  (That WILL break
>ATAPICAM!) 
-- 
Vladimir B. Grebenchikov
[email protected]
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile
To unsubscribe, send any mail to "[email protected]"