Re: Using VESA to restore display settings on resume
"Kevin Oberman" <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.mobile |
|---|---|
| Message-ID | <[email protected]> |
> Date: Thu, 03 Mar 2005 11:34:12 +0100 > From: Jochen Gensch <[email protected]> > Sender: [email protected] > > Rong-En Fan schrieb: > > > I use 3/3's current with this patch on IBM TP X31. I can now successfully > > suspend/resume in X with dri enable on RADEON! (can't do that before, with > > dri, after resume screen mess up). reset_video 0 or 1 both works. It even > > works without vesa module loaded. The only problem is that my tracepoint > > (psm0) dead after resume. > > On my Thinkpad A30p I was able to reactivate my trackpoint after resume > by setting hint.psm.0.flags="0x6000" in /boot/device.hints. > > Could you tell me more about you resume issues? I have a Radeon Mobility > as well an my backlight does not turn off, when going to suspend nuder a > normal CURRENT. Did you also use that DPMS patch posted here a while > ago, or did you only use that vesa patch? hint.psm.0.flags="0x6000" is probably a bit excessive. Mine does fine with hint.psm.0.flags="0x2000". The man page suggests trying 2000 first and 6000 only if 2000 fails. -- R. Kevin Oberman, Network Engineer Energy Sciences Network (ESnet) Ernest O. Lawrence Berkeley National Laboratory (Berkeley Lab) E-mail: [email protected] Phone: +1 510 486-8634 _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-mobile To unsubscribe, send any mail to "[email protected]"