Multiple Fibs and INET6
Santiago Martinez <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.net |
|---|---|
| Message-ID | <[email protected]> |
Hi Everyone. While adding -F ( fib as used in netstat ) to ping and ping6 I have found something that from my understanding is not correct. Please can you advise? I have the following setup : -- two fibs (0 and 1) -- two loop-backs (lo0 and lo1). -- Lo1 has been assigned to fib1 --net.add_addr_allfibs = 0 My interface output looks like this: ifconfig lo0 | grep inet6 inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x2 ifconfig lo1 | grep inet6 inet6 fe80::1%lo1 prefixlen 64 scopeid 0x3 If I do a netstat -rn -6 -F0 I get the following which is was i expected. Internet6: Destination Gateway Flags Netif Expire ::/96 link#2 URS lo0 ::1 link#2 UHS lo0 ::ffff:0.0.0.0/96 link#2 URS lo0 fe80::%lo0/10 link#2 URS lo0 fe80::%lo0/64 link#2 U lo0 fe80::1%lo0 link#2 UHS lo0 ff02::/16 link#2 URS lo0 Now, netstat -rn -6 -F1 shows "fe80::1%lo0" which should not be there and "fe80::1%lo1" is missing which should be there. Internet6: Destination Gateway Flags Netif Expire fe80::%lo1/64 link#3 U lo1 *fe80::1%lo0 link#2 UHS lo0* What output I was expecting was: Internet6: Destination Gateway Flags Netif Expire fe80::%lo1/64 link#3 U lo1 *fe80::1%lo1 link#3 UHS lo1* This makes the ping -6 -F0 fe80::1%lo0 to work but ping -6 -F1 fe80::1%l01 to fail which I wanted to use as test case. Thanks in advance. Santiago