Re: Intermittent failure of routing/gateway with ix(4) (x86_64)

R Tyler Croy <[email protected]> Sun, 24 Aug 2025 01:31:22 +0000

Newsgroups	gmane.os.freebsd.devel.net
Message-ID	<sSicWwTvxOBE6MKtGEVz2jjuAVg4HK5nhZtn1KCEnBNhAyDNlVzWQFXPgAcaj2tDBDKSLQ7RHU3QXeaUbuQVkR4MWcTtiBBejX0k69IYFjA=@brokenco.de>

(replies inline)

On Saturday, August 23rd, 2025 at 6:24 PM, Karl Denninger <[email protected]> wrote:

> 

> What physical hardware is on that driver?
> 

> I have a box here with two ix interfaces in it that is my edge router and beat the SNOT out of it without problems. This is what the boot messages are for them in my machine here:

These are both identical 10GigE NICs, from dmesg

ix0: <Intel(R) X540-AT2> mem 0xe0400000-0xe05fffff,0xe0600000-0xe0603fff irq 18 at device 0.0 on pci1
ix0: Using 2048 TX descriptors and 2048 RX descriptors
ix0: Using 2 RX queues 2 TX queues
ix0: Using MSI-X interrupts with 3 vectors
ix0: allocated for 2 queues
ix0: allocated for 2 rx queues
ix0: Ethernet address: a0:36:9f:38:44:a8
ix0: PCI Express Bus: Speed 5.0GT/s Width x8
ix0: fw 4.2.0 nvm 4.03.0 eTrack 0x8000037c
ix0: netmap queues/slots: TX 2/2048, RX 2/2048

System: FreeBSD 14.2-RELEASE-p4

When I was chasing that arpresolve warning I saw in the console, I did see some discussion like this (https://be-virtual.net/pfsense-arpresolve-cant-allocate-llinfo-for-x-x-x-x-on-emx/) about funky routers on the other end of the link causing trouble. Since this is a newer fiber rollout from my local ISP (Sonic) I wouldn't be surprised if there was something funky happening there. Since the LAN-side routing goes haywire, I'm thinking that's a red herring.

Cheers

signature.asc (application/pgp-signature, 949 B)