Re: IPv6 networking problems in 14.3

Karl Denninger <[email protected]>
Newsgroups gmane.os.freebsd.devel.net
Message-ID <[email protected]>
On 9/14/2025 12:38, Chris Ross wrote:
>> On Sep 14, 2025, at 12:29, Karl Denninger<[email protected]> wrote:
>> Rolling this around in my head some more..... what is the underlying interface?
>> I ask because I saw this happen with "re" driver interfaces (both IPv4 and 6) where it would not get an ARP map and thus couldn't see anything at all on the outside - there were enough other screwball things going on with the "re" driver (timeouts and similar) that I tossed that and now run on ix and a couple of SFP+ transceivers which has been entirely-stable (although igb also appears to work as I've gotten my hands on a box with a couple of those and tested that too.)
> In my case it’s an ix.  Connected to a 1gbps switch interface, but an ix interface.  And, the same hardware that was doing this fine a few months ago.
>
> vlan0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
>          options=4600703<RXCSUM,TXCSUM,TSO4,TSO6,LRO,RXCSUM_IPV6,TXCSUM_IPV6,MEXTPG>
>          ether a4:53:0e:79:b9:82
>          inet A.B.C.D netmask 0xffffff00 broadcast A.B.C.255
>          inet6 fe80::6e8:e675:f359:3465%vlan0 prefixlen 64 scopeid 0x4
>          groups: vlan
>          vlan: 6 vlanproto: 802.1q vlanpcp: 0 parent interface: ix0
>          media: Ethernet autoselect (1000baseT <full-duplex>)
>          status: active
>          nd6 options=1<PERFORMNUD>
>
> ix0: flags=1008843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST,LOWER_UP> metric 0 mtu 1500
> 	options=4e53fbb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4,TSO6,LRO,WOL_UCAST,WOL_MCAST,WOL_MAGIC,VLAN_HWFILTER,VLAN_HWTSO,RXCSUM_IPV6,TXCSUM_IPV6,HWSTATS,MEXTPG>
>          ether a4:53:0e:79:b9:82
>          media: Ethernet autoselect (1000baseT <full-duplex>)
>          status: active
>          nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
>
If you find anything a note back here would be greatly excellent.  I do 
note that per the various notes from long ago I have both tso and lro 
turned off (but I use ipfw, which is where that apparently comes from) 
on the outside interface -- but I doubt that is involved as I did try 
with it on and it didn't change anything.


-- 
Karl Denninger
[email protected]
/The Market Ticker/
/[S/MIME encrypted email preferred]/
smime.p7s (application/pkcs7-signature, 4.3 KB) - not displayed
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.