Re: G5 fans

> On 29. Oct 2018, at 01:31, Koakuma via freebsd-ppc <[email protected]> wrote:
> 
> Hi Michael,
> 
> The first command failed to run for me.
> 0 > dev u3/i2c/fan can't find device u3/i2c/fan ok
> 
> Looking at the output of 'dev / ls', there's several devices named
> "fan" under /smu@0,0/fans@4a00/*, but running the " .status" command
> on those devices gave me this error:
> 0 > " .status" " /smu@0,0/fans@4a00/fan@0" open-dev $call-method
> Method <.status> not found; ihandle=ffb352c0 phandle=ff99ee00
> ok
> 
> This is on a PowerMac11,2, 2 GHz "dual-core" model.
OK. Could you try to run
 " .status" " /smu@0,0/fans@4a00/fan@0" open-dev $call-method
in /smu@0,0/fans@4a00

I was testing on PowerMac7,2 and PowerMac7,3.

Best regards
Michael
> 
> On Sun Oct 28 22:02:15 UTC 2018, Michael Tuexen <tuexen at freebsd.org>
> wrote:
>> Dear all,
>> 
>> if you have access to a G5 Powermac, could you provide the output of the
>> following command from the OpenFirmware prompt:
>> 
>> dev u3/i2c/fan
>> " .status" " u3/i2c/fan" open-dev $call-method
>> 
>> I'm interested in the RPM channels which are reported as Failed/Available/Active.
>> Please provide also some information what kind of PowerMac G5 it is.
>> 
>> Thanks for your help.
>> 
>> Best regards
>> Michael
> 
> _______________________________________________
> [email protected] mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-ppc
> To unsubscribe, send any mail to "[email protected]"