Re: recent problems with PowerMac G5 64 bit USB

> On 9. Dec 2018, at 22:26, Tom Pusateri <[email protected]> wrote:
> 
> I dusted off a PowerMac dual CPU G5 the other day to do some Big Endian Rust debugging. I first tried a Lubuntu 16.04 install image but after installing, I couldn’t get it to boot. yaboot would run and give me a menu to choose linux but when I selected it, it just returned to the mac boot menu. I think they got the open firmware boot command wrong but I can’t figure out what they are calling since it goes by so fast. 
> 
> So then I tried various version of FreeBSD with lots of issues:
> 
> Version			arch		status
> 12.0RC3			powerpc64	USB errors prevented keyboard from working so couldn’t configure it
> 11.2			powerpc64	kernel panic on boot
> 11.2stable20181203	powerpc64	kernel panic on boot
> 11.1			powerpc64	kernel panic on boot
> 11.0			powerpc64	installed ok but portsnap couldn’t fetch/extract ports
> 
> 11.2			powerpc		booted and installed ok. No pkgs. portsnap fetch/extract ok
> 
> So, I’m sure there’s no reason to open bugs on much of this but it does seem odd that 11.2 release images don’t boot and 11.2 stable images don’t boot.
> 
> I’m happy to just use 12.0 and so I’m planning on just opening up a bug report on the USB issues there.
> 
> Anyone else seeing this on 64-bit?
Try booting with SMP disabled. You can do that at the boot loader prompt and if
that works, you can add an entry to /boot/loader.conf.

This get 12 or head working for me (with one CPU) on two dual CPU G5s.

Best regards
Michael
> 
> Thanks,
> Tom
> 
> 
> 
> _______________________________________________
> [email protected] mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-ppc
> To unsubscribe, send any mail to "[email protected]"

_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-ppc
To unsubscribe, send any mail to "[email protected]"