Re: ISA support added to oltr driver

--- "David S. Madole" <[email protected]> wrote: 
> According to trlld.h, 0x400 means "adapter cannot
> interrupt", suggesting a hardware configuration 
> issue with the irq. Is there something else in the
> machine on irq 10 perhaps? Remember, ISA cards
> cannot share interrupts like PCI can.

Yes, there was something else on irq 10.

pci0: <unknown card> (vendor=0x1000, dev=0x000f) at
13.1 irq 10
pci0: <Intel 82371AB/EB (PIIX4) USB controller> at
18.2 irq 10

 
> Might want to check in your BIOS setup to see if
> there is some built-in peripheral, maybe even ACPI,
> on irq 10, or if it's getting assigned to PCI
> devices and adjust the configuration accordingly.

I used the cfg3118.exe utility from the Olicom setup
disk to change the irq.  So, the output from dmesg now
looks like this:

oltr0: <Olicom ISA 16/4 Adapter (OC-3118)> at port
0xa20-0xa3f irq 7 drq 3 on isa0
oltr0: MAC address 00:00:83:7f:7c:a6
oltr0: ring insert (16 Mbps - TXI)
oltr0: Ring status change:  [Soft Error]

I only get one soft error, which I think I can safely
ignore.  

I appreciate all your help.  Thank you!

-Adam


__________________________________
Do you Yahoo!?
Free Pop-Up Blocker - Get it now
http://companion.yahoo.com/
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-tokenring
To unsubscribe, send any mail to "[email protected]"