drm-[stable|next]-kmod and MAXCPU
Claude Buisson <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.x11 |
|---|---|
| Message-ID | <[email protected]> |
Hello, I tried to switch an amd64 Ivy Bridge system (with STABLE-11 @ r338696), from drm2 in base to drm-stable-kmod (and also drm-next-kmod) in ports, after rebuilding the custom kernel without any drm/drm2 module. I installed: gpu-firmware-kmod-g20180825 drm-stable-kmod-g20180822 (and also tried: drm-next-kmod-g20180822 with the same results) Loading "by hand", by rc.conf, or by loader.conf i915kms.ko led to an immediate reboot. I built a GENERIC kernel (without any drm/drm2 module), and everything was OK. So I tried modifying the GENERIC kernel and came to that conclusion: the drm-[stable|next]-kmod ports cannot be used with a kernel built with MAXCPU (at least not defined as 256)!! I commented the MAXCPU line in my custom kernel definition, and got back a working system. May be, the assumptions about kernels could be explicited for ports of this kind ?? Hoping being useful, CBu _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-x11 To unsubscribe, send any mail to "[email protected]"