radeon and drm-kmod still problem
| Newsgroups | gmane.os.freebsd.devel.x11 |
|---|---|
| Message-ID | <[email protected]> |
Hi! I do not know if I am doing something wrong or just doesn't work on my computer. My system: FreeBSD 11.2-RELEASE-p4 (GENERIC md64), computer iMac 11,1, boot manager rEFit, graphics card Radeon HD 4850 (on the FreeBSD wiki page looks like is supported). And I am using portsnap for updating ports. Yesterday I tried again: Built drm-kmod which pulled also drm-stable-kmod and gpu-firmware-kmod. All three were built without problems. I put in /etc/rc.conf kld_list="/boot/modules/radeonkms.ko" and in /boot/loader.conf: hw.syscons.disable=1 kern.vty="vt" I have a question about setting hw.syscons... Shoutl be: set hw.syscons.disable="1" or just hw.syscons.disable=1 because I f I have the last settings or not computer doing the same: after swith to vt it became black with a little tingling and nothing happened. In the /var/messages I got also radeon/RV770_pfp.bin: could not load firmware image, error 2 radeon/RV770_rlc.bin: could not load firmware image, error 2 radeon/RV770_smc.bin: could not load firmware image, error 2 radeon/RV770_uvd.bin: could not load firmware image, error 2 I did try also ati-legacy drivers but result was the same. Thank you. SK _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-x11 To unsubscribe, send any mail to "[email protected]"