Re: Radeon HD 4250: screen going blank every few seconds
Andrea Venturoli <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.x11 |
|---|---|
| Message-ID | <[email protected]> |
On 12/31/18 8:08 AM, Andrea Venturoli wrote: > I think I did it right, since "hw_i2c forced on, you may experience > display detection problems!" is gone from Xorg.log. > However, it didn't help with the screen going blank. Sorry, I was too fast about this, as I had misspelled the line in /boot/loader.conf. When correctly written, the machine boots, but as soon as the kmod is loaded: _ if the screen is connected via VGA connector, everything is fine (but this is also true without this setting); _ if the screen is connected via HDMI, it goes blank for good (can't interact with the system anymore and have to reboot); _ if the screen is connected via DVI, resolution goes to 1024x768 and that's the maximum available even after X11 is started. So, this is a no go. bye & Thanks av. _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-x11 To unsubscribe, send any mail to "[email protected]"