Re: DRM removal soon
Yoshihiro Ota <[email protected]>
| Newsgroups | gmane.os.freebsd.architechture,gmane.os.freebsd.devel.x11 |
|---|---|
| Message-ID | <[email protected]> |
On Sun, 24 Feb 2019 10:24:15 -0700 Warner Losh <[email protected]> wrote: > On Sun, Feb 24, 2019, 3:31 AM Yoshihiro Ota <[email protected]> wrote: > > I also found that running kldstat was the easiest way to find which of > > driver to use instead of dmesg. > > > > Is this a suggestion for changing the drm-kmod package output? Or just a > helpful hint for others? > > Tanks again. > > Warner This is a helpful hint for others and a suggestion to update documents. I had read https://www.freebsd.org/releases/12.0R/relnotes.html#hardware-graphics and https://wiki.freebsd.org/Graphics before I started. I had 4 old laptops and 1 vmawre and I didn't remember which machine uses which CPU :) If the doc can mention to check kldstat output and go to corresponding section, that will make steps easier. I converted to the port based driver for 4 psychical machines and 1 vmware machine (although vmware do not use neither of driver.) All of them run 12.0-RELEASE. All of them start X and work fine. I will likely get to 13-CURRENT a lot later as I ran 13-CURRENT without X and in vmware most of times. Hiro _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-arch To unsubscribe, send any mail to "[email protected]"