Re: Config file location?

"Julian H. Stacey" <[email protected]>
Newsgroups gmane.os.freebsd.devel.x11
Organization http://berklix.com/jhs http://stolenvotes.uk
Message-ID <[email protected]>
Hi, Reference:
> From:		Gary Jennejohn <[email protected]>
> Reply-to:	[email protected]
> Date:		Wed, 5 Jun 2019 09:35:24 +0200

Gary Jennejohn wrote:
> On Tue, 04 Jun 2019 23:13:47 -0700
> "Ronald F. Guilmette" <[email protected]> wrote:
> 
> > Greetings,
> > 
> > It's been quite a long time since I tried to setup and configure a
> > fresh new FreeBSD system, but I am doing that now, using 12.0-RELEASE.
> > Obviously a lot of things have changed.
> > 
> > So far, most everything is working OK.  I have X running and my
> > favorite window manager (fvwm) installed and all is mostly well.
> > 
> > The problem is that I don't much care for the default keyboard
> > repeat rate, and I want to increase it.
> > 
> > In that past, I accomplished this by diddling a couple of lines
> > in the xorg.conf file, but now I can't even seem to find where
> > that is located.  I did do "man Xorg" and checked all of the
> > places listed in the FILES section of that man page, but I still
> > can't seem to find the little bugger.
> > 
> > Does it still exist?  If so, where?
> > 
> 
> Looks like you're right, xorg.conf doesn't seem to exist any more.
> But the man page is still present, so you could generate one based
> on that.

current:
grep / /var/log/Xorg.0.log
	"Builtin Default vesa Screen 0" for depth/fbbpp 24/32
[    41.376] (==) Using default built-in configuration (39 lines)

I too have no xorg.conf in the list of dirs. at base of man Xorg
but see man Xorg:
       -configure
               When this option is specified, the Xorg server loads all video
               driver modules, probes for available hardware, and writes out
               an initial xorg.conf(5)
> 
> If you still have an old xorg.conf from a backup or a running
> system you still copy it to /etc/X11 and the Xorg server will use
> it.  I have a fairly old xorg.conf there and it works.
> 
> The other possibilty would be to use startx und put a ''xset -r''
> command into $HOME/.xinitc.  That's how I do it.
> 
> -- 
> Gary Jennejohn

Cheers,
Julian
-- 
Julian Stacey, Consultant Systems Engineer, BSD Linux Unix, Munich Aachen Kent
 Brexit ref. stole votes from 700,000 Brits in EU; 1.9 M young, more remainers
 had no vote; 1.3 M old mostly leavers died.  Advert lies paid by noses in the
 trough; some foreign funders fined. New referendum now! http://stolenvotes.uk
_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-x11
To unsubscribe, send any mail to "[email protected]"
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.