Re: drm-kmod: AMD Ryzen Vega 8?
Greg V <[email protected]>
| Newsgroups | gmane.os.freebsd.devel.x11 |
|---|---|
| Message-ID | <[email protected]> |
On August 5, 2019 9:19:20 PM GMT+03:00, Grzegorz Junka <[email protected]> wrote: > >On 05/08/2019 16:21, Greg V wrote: >>Though ACPI/EFI/etc related memory mapping improvements happened very >>very recently. I'll retest once again. Update: still, not disabling efifb and launching a display server causes a corrupted image and freezes the system. >>> I don't use grub. >> That (and the above) gives me an idea… I'll try grub :) >I wrote that I do not use grub, right? :) Yes. >I think the >amdgpu module loads but fails to initialize the graphics card since >after that I don't see any other drm messages. I am getting the same >message ([drm] amdgpu kernel modesetting enabled.) when I try to load >amdgpu manually from the command line after the system is fully booted >("kldload amdgpu"). No no no, if a GPU driver *fails*, it makes a lot of noise. If it only shows "enabled", it did not find any supported GPUs at all. Which would make sense if you're on the packaged 4.16 drm, as support for VegaM was added later. You need to install 5.0 from git. By the way: loading amdgpu only on that laptop would probably be pointless, you need to keep i915kms loaded and then kldload amdgpu. _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-x11 To unsubscribe, send any mail to "[email protected]"