Re: Finally got touchpad working on Dell Precision 7520

> On 28. Feb 2021, at 14:56, David Wolfskill <[email protected]> wrote:
> 
> Turns out that the touchpad on the Precision 7520 (and likely several
> other "newer" (last few years) laptops uses I2C.
> 
> For stable/12, I had built/installed the sysutils/iichid port;
> iichid is part of base FreeBSD in stable/13 and head.  And while
> the mouse works (under X11 -- not on a vty) in stable/13 & head;
> it still does not work under stable/12.
> 
> I had appended:
> 
> hw.usb.usbhid.enable=1
> iichid_load="YES"
> 
> 
> to /boot/loader.conf for each of stable/12, stable/13, and head.  For
> the latter two, I see several additional kernle modules brought in (such
> as hms.ko, hidmap.ko, and hkbd.ko); I don't see them either in base
> stable/12 or in ports (though I may not know where to look).
> 
> But it's progress!
> 

Hi David,

Did you already try sysutils/iichid on 12? (its functionality was merged into 13 not too long ago).

Cheers,
Michael

p.s. Meant to write you yesterday, but somehow got distracted


> Peace,
> david
> -- 
> David H. Wolfskill                              [email protected]
> It is supremely disingenuous to claim a lack of jurisdiction, then     
> proceed to participate in a decision on the same matter.
> 
> See https://www.catwhisker.org/~david/publickey.gpg for my public key.

_______________________________________________
[email protected] mailing list
https://lists.freebsd.org/mailman/listinfo/freebsd-x11
To unsubscribe, send any mail to "[email protected]"