Re: FAILURE - WRITE_DMA timed out

Danny MacMillan <[email protected]>
Newsgroups gmane.os.freebsd.newbies
Message-ID <[email protected]>
On Sat, Jan 22, 2005 at 10:15:47PM +1100, Jo Bailey wrote:
> I'm getting the following timeout messages, I've copied the interesting 
> dmesg output below. Has anyone got any suggestions on what is causing this 
> or point me in the right direction?
> 
> The hardware is a standard Acer Altos R310.
> 
> acpi_cpu: throttling enabled, 8 steps (100% to 12.5%), currently 100.0%
> acd0: CDROM <SR244W1/T01A> at ata0-master UDMA33
> ad2: 76319MB <ST380013AS/3.05> [155061/16/63] at ata1-master SATA150
> Mounting root from ufs:/dev/ad2s1a
> em0: Link is up 100 Mbps Full Duplex
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=9611455
> ad2: FAILURE - WRITE_DMA timed out
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=9627231
> ad2: FAILURE - WRITE_DMA timed out
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=5095231
> ad2: FAILURE - WRITE_DMA timed out
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=9611455
> ad2: FAILURE - WRITE_DMA timed out
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=5095231
> ad2: FAILURE - WRITE_DMA timed out
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=9625791
> ad2: FAILURE - WRITE_DMA timed out
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=9611267
> ad2: FAILURE - WRITE_DMA timed out
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=9611455
> ad2: FAILURE - WRITE_DMA timed out
> ad2: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=9627327
> ad2: FAILURE - WRITE_DMA timed out

There's been a lot of traffic on this in -questions@ lately; searching
the archives should stand you in good stead.

-- 
Danny
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-newbies
To unsubscribe, send any mail to "[email protected]"
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.