Re: Raspberry π questions allowed here?

to reply to my own Q…my mistake may have been choosing 15, when 13
seems to be better supported.

On Thu, Feb 19, 2026 at 6:03 PM paul beard <[email protected]> wrote:
>
> I just imaged an SD card of 15.0 and installed it in a Raspberry π
> model 4, but it doesn't seem to show up on the network.
>
> sudo dd if=~/Downloads/FreeBSD-15.0-RELEASE-arm64-aarch64-RPI.img
> of=/dev/disk4 bs=1m conv=sync after verifying that disk4 was the SD
> card. I could have used disk4s1…is this where my troubles begin?
>
> "For convenience for those without console access to the system, a
> freebsd user with a password of freebsd is available by default for
> ssh(1) access. Additionally, the root user password is set to root; it
> is strongly recommended to change the password for both users after
> gaining access to the system."
>
> This seems to assume that DHCP will get an address for it and make it
> accessible.
>
>
> --
> Paul Beard / www.paulbeard.org/



-- 
Paul Beard / www.paulbeard.org/