Re: [FreeBSD-Announce] FreeBSD Security Advisory FreeBSD-SA-19:07.mds
Borja Marcos via freebsd-security <[email protected]>
| Newsgroups | gmane.os.freebsd.security.general |
|---|---|
| Message-ID | <[email protected]> |
> On 15 May 2019, at 16:33, mike tancsa <[email protected]> wrote: > >> on /etc/rc.conf with the devcpu-data port installed and as far as I know it updated the microcode. >> >> The script in /usr/local/etc/rc.d used cpucontrol(8) to load it. >> >> Or am I holding it wrong? > > Supposedly 2 ways to do it. When you install the port, it writes .... > and I missed the part where it says running FreeBSD 12.0…. Ah yes, I've always been doing this since FreeBSD 11. Using the port, not the loader.conf stuff. Borja. _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-security To unsubscribe, send any mail to "[email protected]"