Re: 504 gateway time-outs

Mark Millard <[email protected]>
Newsgroups gmane.os.freebsd.stable,gmane.os.freebsd.current
Message-ID <[email protected]>
On 2/28/26 17:57, Kevin Oberman wrote:
> On Sat, Feb 28, 2026 at 5:48 PM Kevin Oberman <[email protected]
> <mailto:[email protected]>> wrote:
> 
>     On Sat, Feb 28, 2026 at 3:33 AM Graham Perrin
>     <[email protected] <mailto:[email protected]>> wrote:
> 
>         On 28/02/2026 10:32, Mark Millard wrote:
>         > …
>         >
>         > The following got "504 Gateway Time-out" when I tried them:
>         >
>         > <https://pkg-status.freebsd.org/beefy24/build.html?
>         mastername=main-amd64-default&build=pdf4f957ea181_s178d0b5b8d
>         <https://pkg-status.freebsd.org/beefy24/build.html?
>         mastername=main-amd64-default&build=pdf4f957ea181_s178d0b5b8d>>
>         >
>         > <https://pkg-status.freebsd.org/beefy23/build.html?
>         mastername=150amd64-default&build=df4f957ea181 <https://pkg-
>         status.freebsd.org/beefy23/build.html?mastername=150amd64-
>         default&build=df4f957ea181>>
> 
> 
>         Both somewhat slow to load, however they do load for me.
> 
>         Thanks
> 
>      
>     beefy22 is showing hte same issues. Something is tying up the
>     builders with builds hanging in "build-depends" and "lib-depends"
>     for very long periods of time, as long as over 4 hours) with high
>     load averages. This has been going on for months and seems to be
>     getting worse. Chromium builds which used to take around 20 hours
>     are now running around 40 and I really don't think that this is just
>     code bloat. At times, about half of the active builds are in some
>     state other than "build"; mostly one of the depends states which
>     should never take long as all dependencies are built before a build
>     is started.
> 
>     After some time passes (often hours) things clear up. Dependencies
>     are suddenly loaded in a few minutes or less. Note that things do
>     continue to complete, but the 10 minute averages are in single
>     digits and frequently go to 0. During this time, my connection to
>     beefy22 will timeout and sometimes I can't establish a connection.
> 
>     I don't have any special access to the machines... just via pkg-
>     status, so I'm fairly limited in any analysis.
> 
> 
> Just before I started my last message,  all was well, but I last saw
> were a dozen builds in one of the "depends" states and "impulse" at 74
> when I lost my connection. I can reconnect to the beefy22 status page,
> but it has not updated for several minutes.
> -- 
> Kevin Oberman, Part time kid herder and retired Network Engineer
> E-mail: [email protected] <mailto:[email protected]>
> PGP Fingerprint: D03FB98AFA78E3B78C1694B318AB39EF1B055683


FYI:

beefy22 got an extract/timeout failure for attempting to build
qt6-webengine-6.10.2:

. . .
===>  Extracting for qt6-webengine-6.10.2
=> SHA256 Checksum OK for
KDE/Qt/6.10.2/qtwebengine-everywhere-src-6.10.2.tar.xz.
=>> Killing timed out build after 7200 seconds
=>> Cleaning up wrkdir
===>  Cleaning for qt6-webengine-6.10.2
. . .

qt6-pdf-6.10.2 also got an extract/timeout failure.


So it seems that it is not just the pkg-status.freebsd.org presentation
pages that end up messed up.


-- 
===
Mark Millard
marklmi at yahoo.com
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.