Setting up GPIO pins from a overlay
Brad Spencer <[email protected]>
| Newsgroups | gmane.os.netbsd.current |
|---|---|
| Message-ID | <[email protected]> |
Setting up the nature of a GPIO pin from an overlay appears to be possible with Linux. Since overlay incantations for Linux really do not seem to work with NetBSD, I was wondering if anyone has done this with a NetBSD overlay?? In particular, I would like pin 17 on a GPIO port to be configured as an output pin, low from an overlay being used on a RPI3. Yes, I realize that I can set it with /etc/gpio.conf later, but it would be helpful if the pin started life out as a output pin, low... -- Brad Spencer - [email protected]