SBP2 Login problem

hi james,

in my earler mail i sent u the new fwohci_pktget(). In that function i m using 
bus_dmamap_sync() with a PREREAD option. 
I m using RBHMA4200 Target board for TX4927 processor. With the POSTREAD 
option, the fwohci_buf_pktget() is not able to read the new descriptor map as 
it was not updated on the memory. Thus i have to soft reset the board around 
100 times to read the config ROM of the SBP2 device.
With the PREREAD option i m able to read the Config ROM in 1 shot. When i 
write the address of the login ORB on to the target device(1394 HDD), I 
recieve a READ REQUEST BLOCK from the HDD. In responses to this LOGIN ORB is 
sent to the device as READ RESP BLOCK. After doing this i recieve the 
ackcomplete from the target but then It stucks. i.e. there is no Interrupt 
from the device for WRITE REQUEST BLOCK.

Can u suggest where is the problem.

Also there is one more problem that i faced with the FWOHCI code, ie. when i 
boot the system, the code reads the value of MAX_REC field from then 
BUSOPTIONS REGISTER as 0, so i HARDCODED it to 0xA(2048).



-- 
Regards,
Rishabh Kumar Goel
Associate Software Engineer
SoCrates Software India Pvt. Ltd.
Bangalore

Scanned by SecureSynergy VirusScreen Service. 
For more information log on to : http://www.securesynergyonline.com or http://www.securesynergy.com