Re: MNT Reform2 USB LCP flash

Michael van Elst wrote:
> On Sat, Feb 03, 2024 at 09:55:47PM +0200, Staffan Thomén wrote:
>> Staffan Thomen wrote:
>>> [ 188.679957] sd0: 34816, 1 cyl, 64 head, 32 sec, 512 bytes/sect
>>> x 68 sectors [ 188.689958] autoconfiguration error: sd0: unable
>>> to open device, error = 5
>> Any thoughts of how to continue debugging this?
>
>
> A kernel compiled with SCSI_DEBUG can show which commands to the
> device actually fail and how. This should be the initial
> TEST_UNIT_READY and possibly the START command. No idea why, it's
> possible that these are not implemented and errors need to be
> ignored.

I built a kernel with options SCSIDEBUG, SCSIVERBOSE and SCSI_DEBUG, and
saw nothing new in the dmesg.

The man page for scsi(4) says that SCSIDEBUG (not SCSI_DEBUG) enables
ioctls for extra printfs, so I wrote this small program to run the
ioctl, but it still fails on the open call with Input/output error (EIO).

I tried /dev/sd0, /dev/sd0d, /dev/rsd0, /dev/rsd0d, /dev/sd0c and
/dev/rsd0c.

For good measure, I tried it on /dev/scsibus0 and that gave me an EFAULT
from ioctl.

I just now noticed that scsictl actually implements this ioctl as well,
but it also errors out with EIO.

The man page for scsictl(8) says that SCSIPI_DEBUG is the required option...

I think I'm more confused than before now. What enables scsi command
debugging?

Staffan

--8<--

#include <stdio.h>
#include <stdlib.h>
#include <errno.h>

#include <unistd.h>
#include <fcntl.h>
#include <sys/ioctl.h>
#include <sys/scsiio.h>

int main(int argc, char **argv) {
         if (argc < 2) {
                 printf("Usage: %s <device>\n", getprogname());
                 return -1;
         }

         int fd = open(argv[1], O_RDONLY);

         if (fd == -1) {
                 perror("open");
                 return -1;
         }

         int result = ioctl(fd, SCIOCDEBUG, 0x15);

         if (result == -1)
                 perror("ioctl");

         close(fd);

         return 0;
}