Re: MNT Reform2 USB LCP flash
Michael van Elst <[email protected]>
| Newsgroups | gmane.os.netbsd.devel.kernel |
|---|---|
| Message-ID | <[email protected]> |
On Sun, Feb 04, 2024 at 10:37:59AM +0200, Staffan Thomen wrote:
> [ 214.0188739] umass0: NXP (0x1fc9) LPC1XXX IFLASH (0x000b), rev 2.00/7.04,
> [ 214.0288745] sd0(umass0:0:0:0): sense debug information:
> [ 214.0288745] code 0x70 valid 0
> [ 214.0288745] seg 0x0 key 0x2 ili 0x0 eom 0x0 fmark 0x0
>
> [ 214.0288745] info: 0x0 0x0 0x0 0x0 followed by 10 extra bytes
> [ 214.0288745] extra (up to 10 bytes): 0x0 0x0 0x0 0x0 0x30 0x1 0x0 0x0
> 0x0 0x0
That's what the device answers, but I cannot tell why. Maybe
the device is not (yet) in the correct mode to accept USB
access.
The product code 0x1fc9:0x000b seems to be a LPC11U24,
there is an application note AN11305 from NXP for
"USB In-System Programming with th LPC11U3X/LPC1U2X",
but I didn't find any hints in that document.
Greetings,
--
Michael van Elst
Internet: [email protected]
"A potential Snark may lurk in every tree."