Re: NAS
Ted Spradley <[email protected]>
| Newsgroups | gmane.os.netbsd.general |
|---|---|
| Organization | 97% Talent Free |
| Message-ID | <[email protected]> |
On Thu, 2 Apr 2026 15:01:07 +0200 Alexander Schreiber <[email protected]> wrote: > Depends on your needs. I'm using Gigabyte MB10 Datto (OEMed for Datto > NAS appliances) for Ceph nodes - yes, running Linux, but it's a very > standard x86 board so I expect NetBSD to run fine. Supports ECC (important > for storage nodes) and has 6 SATA ports (my setup uses 1 SATA SSD for the > system and 5x SATA disk for storage). I chose an Asrock C3558D4I-4L a few years ago because it has lots of SATA ports and ECC RAM. Way overkill for my needs really, but I didn't know about SATA port multipliers. I have 8 spinning rusts (4 mirrored pairs) plus an M22 for the OS, FreeBSD, because I want ZFS. It's an Intel processor, so not suitable for Martin. I'm wasting a lot of electricity. -- Ted Spradley <[email protected]>