Re: PCMCIA ne2000 compatible Ethernet card driver

On Wed, Mar 12, 2008 at 05:48:02PM -0400, Christos Zoulas wrote:
> On Mar 12, 10:33pm, [email protected] (Manuel Bouyer) wrote:
> -- Subject: Re: PCMCIA ne2000 compatible Ethernet card driver
> 
> | On Wed, Mar 12, 2008 at 06:44:58PM +0000, Christos Zoulas wrote:
> | > In article <[email protected]>,
> | > Manuel Bouyer  <[email protected]> wrote:
> | > >-=-=-=-=-=-
> | > >
> | > >On Sun, Mar 09, 2008 at 09:09:19PM -0300, Javier Steinaker wrote:
> | > >> Hi again,
> | > >> 
> | > >> Under Puppy Linux, I ejected the card and inserted it
> | > >> again. The results in dmesg:
> | > >> 
> | > >> -------------------------------------------------
> | > >> pccard: card ejected from slot 0
> | > >> pccard: PCMCIA card inserted into slot 0
> | > >> pcmcia: registering new device pcmcia0.0
> | > >> eth0: NE2000 Compatible: io 0x300, irq 3, hw_addr
> | > >> 00:C0:0C:03:78:F1
> | > >> -------------------------------------------------
> | > >> 
> | > >
> | > >     { PCMCIA_VENDOR_INVALID, PCMCIA_PRODUCT_INVALID,
> | > >+      PCMCIA_CIS_EXP_THINLAN100,
> | > >+      0, -1, { 0x00, 0xc0, 0x0c }, 0 },
> | > 
> | > I think the above line should be:
> | > 
> | > 	0, 0x0ff0, { 0x00, 0xa0, 0x0c }, 0 },
> | 
> | Linux reports 00:c0:0c as mac address ...
> | And I guess if this was the issue, he wouldn't get "were did the card go"
> | error, it would fail before that ...
> 
> I looked in the linux pc_net driver code for NE 2000 compatible...

So did I. 0x00, 0xa0, 0x0c doens't match the ethernet address reported
by Javier. 

-- 
Manuel Bouyer <[email protected]>
     NetBSD: 26 ans d'experience feront toujours la difference
--