Re: Install failure 1.6.1_RC2

On Mon, Mar 17, 2003 at 02:11:48AM -0000, Chris Gilbert wrote:
> Frank Wennmohs said:
> > On Sun, Mar 16, 2003 at 12:42:50PM +0000, Gavan Fantom wrote:
> >> On Sat, 15 Mar 2003, Frank Wennmohs wrote:
> >>
> >> > Yes, I am also using quite a plain system:
> >> > RPC700 board, internal IDE, SA110, 64MB
> >>
> >> Just to rule this out, whivh revision of the SA110?
> >>
> > Revision S
> 
> >> > The whole installation was from scratch.
> >> > I just did an installation of 1.6O (200302240000)
> >> > and the problem does not occur.
> >> >
> >> > Any suggestions?
> >>
> 
> Could you try 1.6, see if it was broken then, narrows it down to a change
> that was pulled up...
> 

The problem did not occur with 1.6



> >
> > I tried to compile X with -current, but there seem to be
> > some pthread problems. It compiled correctly, but
> > when trying to startx it stops because of problems with pthread.
> > But due to the fixed dynamic linker it's ways faster.
> 
> Hmmm, could you PR that one?  Just so we don't lose track of the PR's
> (even if we let them rot, we at least track the rot 8)
> 

I am going to verify that one by building it again tonight.
With the xsets provided on releng.netbsd.org 1.6O does seem
to run smoothly so far.


Frank

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (FreeBSD)

iD8DBQE+dYnGQVAohVxat4gRAnBYAJ0R2MvEgY/lQpgJEmgC11xcpPjDQQCdGLkJ
TxUZgFtVcrOdhi/aD2bMGe0=
=c7TP
-----END PGP SIGNATURE-----