Amiga screen modes in wscons

Hi everyone!=0A=
=0A=
Is there a way to change the screen mode used by wscons at boot time? As fa=
r as I know, the only choice is to use or not use -A in boot block or loadb=
sd.=0A=
=0A=
I am asking because I got a new scandoubler for my Amiga 1200 and after spe=
nding some time with all possible tweaks on it, the closest I can get to a =
perfectly visible wscons screen booting with "netbsd -ASn2" is this one [1]=
, that is almost there, missing the very first column of the display. Howev=
er, if I remove -A and boot with "netbsd -Sn2", I get perfect alignment in =
the screen [2], but I give up the AGA support and Xorg is launched in monoc=
hrome.=0A=
=0A=
Regards,=0A=
Carlos=0A=
=0A=
[1] https://i.postimg.cc/FHJrK3wk/warpedvision-netbsd-aga.png=0A=
[2] https://i.postimg.cc/VsGmBK8b/warpedvision-netbsd-ecs.png=0A=
=0A=
Carlos Mil=E1n Figueredo=0A=
HispaMSX System Operator=0A=
- http://www.hispamsx.org=0A=
-=A0telnet://bbs.hispamsx.org=0A=
-=A0https://calnus.com=