Re: Trying to install NetBSD on quartz64 model B

[email protected] (Michael van Elst)
Newsgroups gmane.os.netbsd.ports.arm
Organization Serpens User Group
Message-ID <[email protected]> 
[email protected] (Ludovic Hirlimann) writes:

> 3. connect serial (but I forgot to connect 3.3v)

When you connect the console, you use 3 wires for GND, TX, RX.
If your USB-serial adapter has a 3.3V (or even 5V) wire, don't
connect it anywhere.

You need to cross TX and RX (TX cable goes to RX pin and RX cable
goes to TX pin). From the image I cannot tell if that's done right.

Some USB-serial devices don't support 1.5Mbps, but Jared's UEFI
image is patched to configure the console to 115200bps.


Greetings,
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.