Re: armv7.img does boot on BeagleBone (White)
Aleksey Cheusov <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.arm |
|---|---|
| Message-ID | <[email protected]> |
>> Hi everyone. >> >> My board is described here: >> https://wiki.logre.eu/index.php/BeagleBone_White >> >> I've downloaded image from here >> https://cdn.netbsd.org/pub/NetBSD/NetBSD-10.0/evbarm-earmv7hf/binary/gzimg/armv7.img.gz >> >> Then, I ungzipped it and dd-ed it to MicroSD card >> >> Then, I booted my board. >> >> That's what I see: >> >> 0 cheusov>cu2bone >> Connected. >> CCCC >> >> Image looks like the following >> >> [root@ryzen Downloads]# file ./armv7.img >> ./armv7.img: x86 boot sector; partition 1: ID=0xc, active, starthead 10, startsector 32768, 163840 sectors; partition 2: ID=0xa9, starthead 60, startsector 196608, 2451456 sectors >> [root@ryzen Downloads]# >> >> MicroSD is fine. OpenBSD and Linux booted correctly. >> dd-ing method (on Linux) was the same: >> >> dd if=armv7.img of=/dev/sdd bs=1M status=progress oflag=nocache >> >> What's wrong? > Did you add a Beagle Bone (white) u-boot to the image? No. Is it necessary? I just copied image to SD-Card as is. > CCCC is what the SoC maskrom bootloader puts out on serial console when it can't find platform firmware.