Re: Marvell kernel on Zyxel NSA310

On Fri, Aug 16, 2024 at 12:34:36PM +0900, Rin Okuyama wrote:
> On 2024/08/16 12:18, Rin Okuyama wrote:
> > Our makphy(4) driver does not support MV88E1318 (even for -current).
> > 
> > At first glance for Linux driver, this chip needs some special handling;
> > see drivers/net/phy/marvell.c from github.com:torvalds/linux.
> > 
> > What happens if you add ukphy(4), general PHY driver, to your kernel
> > config?

> Do you have makphy(4) driver in your kernel config?

 # MII/PHY support
 makphy*        at mii? phy ?                   # Marvell Semiconductor 88E1000 PHYs
+rgephy* at mii? phy ?                   # Realtek 8169S/8110S/8211 PHYs
+rlphy*  at mii? phy ?                   # Realtek 8139/8201L PHYs
+ukphy*  at mii? phy ?                   # generic unknown PHYs

I threw in all these, since they were in the sheeva config. Don't see
any messages from them. makphy was in the MARVELL_NAS config to start
with.

> > BTW, sorry if discouraging you, but there are some problems for mvsoc:

That's perfectly fine. Thank you. It's nice to know there's known
problems and not just mysteries. It's not exactly a current or important
device either for me. Just an interesting experiment.


I also have a Synology DS207+ but that is missing several useful uboot
commands. Only hope for it would seem to be TFTP.

     ** MARVELL BOARD: Synology Disk Station LE

    U-Boot 1.1.1 (Aug 10 2007 - 19:12:18) Marvell version: 1.11.2

    DRAM CS[0] base 0x00000000   size 128MB
    DRAM Total size 128MB
    [4096kB@ffc00000] Flash:  4 MB
    Addresses 20M - 0M are saved for the U-Boot usage.
    Mem malloc Initialization (20M - 16M): Done
    Using default environment

    Soc: 88F5281 D0
    CPU: ARM926 (Rev 0) running @ 500Mhz
    Orion 2 streaming disabled
    VFP initialized to Run Fast Mode.
    SysClock = 166Mhz , TClock = 166Mhz

    Model: DS-207+
    CPLD version: 0x0
    FAN Status: Running

    USB 0: host mode
    CPU: Write allocate enabled
    Net:   egiga0 [PRIME]
    Press Ctrl+C to abort autoboot in 1 second

Slightly different hardware, but might as well try that if I get around
to setting up a boot server.