Re: BeagleBone Black and GPIO issues

> On Oct 13, 2024, at 9:52 PM, Lloyd Parkes <[email protected]> wrote:
> 
> I suspect there hasn't been a sufficient confluence of FDT pinctrl
> understanding and BBB hardware to make this happen. Neither should be
> super difficult, but we need both. Also, TI's documentation doesn't
> help with it's barking made register names.

I agree, the names are needlessly complicated.

I have, however, found this driver

	https://patchwork.ozlabs.org/project/uboot/patch/[email protected]/

which seems to be what is needed.  I think it might match the following in sys/external/gpl2/dts/dist/arch/arm/boot/dts/am33xx-l4.dtsi:

scm: scm@0 {
	compatible = "ti,am3-scm", "simple-bus";
	reg = <0x0 0x2000>;
	#address-cells = <1>;
	#size-cells = <1>;
	#pinctrl-cells = <1>;
	ranges = <0 0 0x2000>;

	am33xx_pinmux: pinmux@800 {
		compatible = "pinctrl-single";
		reg = <0x800 0x238>;
		#pinctrl-cells = <2>;
		pinctrl-single,register-width = <32>;
		pinctrl-single,function-mask = <0x7f>;
	};

That block starts (@0) at 0x44e10000 and the 0x800 offset is the GPIO control registers.

Does this look right?

Cheers,
Brook