Re: Wireguard interface on RPI evbarm

El 30/4/26 a las 13:18, Mayuresh escribió:
> # uname -a
> NetBSD pinas 10.1 NetBSD 10.1 (GENERIC64) #0: Mon Dec 16 13:08:11 UTC 2024  [email protected]:/usr/src/sys/arch/evbarm/compile/GENERIC64 evbarm
> 
> 
> On above system, it seems wireguard interface wg is not supported:
> 
> # ifconfig -C
> ipsec vether bridge carp pppoe vlan tun tap ppp lo gre gif npflog
> 
> Tried using wg-userspace:
> 
> # wg-userspace  0 create
> [   1.0000000] entropy: ready
> [   1.0200050] WARNING: module error: built-in module crypto failed its MODULE_CMD_INIT, error 17
> rump_sp: failed to bind to URL unix:///var/run/wg_rump.0.sock
> rump server init failed: Address already in use
> rump.ifconfig: clone_command: File exists
> rump.ifconfig: exec_matches: File exists
> rump.ifconfig: SIOCSLINKSTR: Device busy
> 
> 
> Is there any way to configure wg0 on RPI running evbarm 10.1?
> 

Hello Mayuresh,

I had to config /etc/modules.conf to load the module at boot in my RPiZeroW in 
order to work:

# cat /etc/modules.conf


if_wg


Regards.