Re: netwinder continued - is this normal behaviour?

At 11:41 AM 6/25/2002, Chad Walters wrote:
>Here's how I thought I would be able to setup NetBSD on my Netwinder.
>Do a diskless boot by booting the kernel from the network using tftp
>and use nfs to provide a root filesystem. Then use disklabel and
>fdisk to setup the hard drive and finally extract all the necessary
>binary sets.
>
>I used base.tgz , etc.tgz and kern-GENERIC.tgz which I acquired from:
>ftp://releng.netbsd.org/pub/NetBSD-daily/200206220000/netwinder/binary/sets/
>
>When I'm greeted by the firmware prompt I set the following variables:
>
>load-defaults
>setenv netconfig_eth0 flash
>setenv eth0_ip 192.168.1.6/24
>setenv kernconfig tftp
>setenv kerntftpserver 192.168.1.1
>setenv kerntftpfile /netbsd
>setenv rootconfig nfs
>setenv rootpath 192.168.1.1:/usr/local/nfs
>save-all
>boot
>
>That fetches the kernel from the network but as soon as it's done
>downloading and about to start booting, my monitor goes blank and the
>keyboard doesn't respond. Does this mean the kernel defaults to using
>the serial interface for I/O or something more serious?

The kernel only uses the serial interface at the present time.

>By the way, I upgraded the Netwinder firmware(2.3.3) by following the
>instructions from this document(not sure if that might have anything to
>do with this issue):
>http://www.netwinder.org/howto/Firmware-HOWTO-3.html
>
>

-- 
Matt Thomas               Internet:   [email protected]
3am Software Foundry      WWW URL:    http://www.3am-software.com/bio/matt/
Cupertino, CA             Disclaimer: I avow all knowledge of this message