Re: problems with tlp0 (tulip) on Netwinder

I'd recommend you try recompiling the kernel with de enabled and tlp
disabled, see if that makes it work.

if you can't recompile a kernel I probably can in the next couple of days
(note pester me or I'll forget!!!)

btw what's the dmesg output for the network card?

Chris
----- Original Message -----
From: "Stefan Wuerthner" <[email protected]>
To: <[email protected]>
Cc: <[email protected]>
Sent: Wednesday, September 04, 2002 11:08 PM
Subject: problems with tlp0 (tulip) on Netwinder


> Hi,
>
>
> I finally managed to install a build of NetBSD 1.6 on my Netwinder.
>
> Unfortunately the tlp0 interface (tulip) doesn't work as expected.
>
> After trying to configure it with e.g.
>
> ifconfig tlp0 192.168.24.50
>
> I get the following error messages:
>
> tlp0: transmit process failed to idle: state RUNNING - READING
> tlp0: receive process failed to idle: state RUNNING - CHECK
> tlp0: transmit process stopped
> tlp0: receive process stopped
> tlp0: transmit process failed to idle: state RUNNING - READING
> tlp0: receive process failed to idle: state RUNNING - CHECK
> tlp0: transmit process stopped
> tlp0: receive process stopped
>
> and so on...
>
>
> Any ideas?
>
>
> Stefan
>
> --
> --------------------------------------------------------------------------
---
> Stefan Wuerthner                              web
http://wuerthner.dyndns.org
> --------------------------------------------------------------------------
---
>